Showing 17–22 of 22 results
Filaticum Support is a PLA-based filament, developed for 3D printings which need support.
As opposed to the soluble support materials Filaticum Support is an easy to break-away filament, so the vast majority of the support material can be removed quickly. Any remaining support on the surface can be completely removed by sanding. The result is a clean printing surface, there is no or minimal need for post-processing.
Also suitable for printing the complexly structured supports. It is compatible with FDM filaments and works well with them.
Printing with Filaticum Support is simple, settings are similar to PLA’s: printing temperature 190-215 0C, bed temperature 60 0C.
The strength, hardness, and heat resistance of filament reinforced with glass fiber go far beyond the characteristics of the standard PLA. It can withstand heat of up to 100 0C. The biopolymer-based filament is also suitable for printing lightweight parts, even applicable for replacing metal parts. The printed surface is unique, glassy, so it is also a perfect choice for designers. The warping of objects printed with Filaticum Glass Reinforced is very low. Recommended printing parameters: 215 0C nozzle, 60 0C bed. If you are printing continuously in bigger quantities (above 1-2 kg), hard nozzles are recommended, in this case the printing parameters should be adjusted accordingly. Direct drive is recommended.
Filaticum Cleaning was designed for cleaning the extruder and the nozzle. This special filament incorporates short glass fibers thus removes staining and polishes the inner surface. Recommendation of use: print about 20 cm filament which cleans the extruder. If the outflow material clean, it means that the extruder is also clean. In some cases a little bit more material is needed. The efficiency of the cleaning process could increase, if you stop the printing for a while and then continue it. Regular use of Filaticum Cleaning reduces the plugging, increase the shelf life of the extruder. It is also strongly recommended if you changes often the different colored filaments or swap different raw materials.
Transparent PLA filaments have a slight yellowish color, in addition, if you print thicker objects, the transparency disappears. With Filaticum High Transparent you can get an almost water-clear finish. It is an easy-to-print filament, in a wide range of printing temperature. The transparency of the printed object can be improved by changing the printing parameters: a nozzle with larger diameter, and the lowest possible layer height. It’s important to know that the texture of the print can also affect the transparency, and the best results can be obtained by printing single-layer walls.
PETG is an ideal choice for 3D printing when reduced warping and high heat resistance are important requirements. Objects printed with PETG are heat resistant up to 85° C, and they are also resistant to chemical influences (e.g. chemicals, solvents, biologically active agents). Printing with PETG is almost as simple as with PLA. PETG is odorless when printing.
The new generation ABS filament is designed for printing more durable, impact resistant, heat resistant objects. Thanks to the automotive-grade raw material and additives, the shrinkage of an object printed with Filaticum ABS is very low, while its impact resistance is extremely high. The surface of the printed object has a matt, silky effect.