Black
Showing 17–19 of 19 results
-
DetailsFilaticum PA Carbon
29 990 Ft 23 614 Ft + VAT Add to cartStrong, rigid and heat resistant (up to 180°C) composite. Polyamide 6 stands as one of the toughest materials utilized in FFF 3D printing. Its exceptional mechanical strength, stiffness, vibration damping capabilities, and wear resistance surpass those of other filament types. In addition, it offers excellent chemical resistance also.
The carbon fiber content diminishes shrinkage, which is common in most high-temp materials, so that it simplifies the printing process also. The carbon fiber enhances more the stiffness and tensile strength (up to 120 MPa) of filament.
-
DetailsFilaticum Fuzzy
9 990 Ft 7 866 Ft + VAT Add to cartFilaticum Fuzzy filament was developed to create unique objects with a special surface. The layers typical for FDM 3D printing are blurred, almost disappeared, as a fluffy, fuzzy surface is formed over them. This is combined with a matt effect.
Filaticum Fuzzy is PLA-based filament, therefore PLA printing settings can be used as a baseline, and then, the surface texture of the printed object can be modified by varying the printing temperature. Recommended bed temperature: 60 °C.
For an even more special look, with a lower flow a surface with “craters” can be achieved.
In addition to the unique surface, the impact resistance of the material is also very good, it is easy to sand, post-process and glue also. The Z-axis adhesion of the print is also better compared to standard PLA filament.
To achieve the characteristic surface, in addition to PLA this filament contains additives, making it somewhat stiffer than usual. Due to the nature of the filament, it is prone to stringing, but this can be easily removed after printing without traces.
The spools weigh 750 grams, but they contain the same amount of filament length as standard 1 kg PLA filaments, so the material requirement should be calculated accordingly.
-
DetailsFilaticum Glass Reinforced
18 990 Ft – 63 290 Ft 14 953 Ft + VAT Add to cartThe strength, hardness, and heat resistance of filament reinforced with glass fiber go far beyond the characteristics of the standard PLA. It can withstand heat of up to 100 0C. The biopolymer-based filament is also suitable for printing lightweight parts, even applicable for replacing metal parts. The printed surface is unique, glassy, so it is also a perfect choice for designers. The warping of objects printed with Filaticum Glass Reinforced is very low. Recommended printing parameters: 215 0C nozzle, 60 0C bed. If you are printing continuously in bigger quantities (above 1-2 kg), hard nozzles are recommended, in this case the printing parameters should be adjusted accordingly. Direct drive is recommended.